8
Fig 3
Key button functions introduction
Button name
Function introduction
ESC
back to up-level menu
Setup
hold for 3 seconds, enter into keyboard configuration state (default password: 8888)
Search
press 1 second, check keyboard configuration: PTZ protocol
Shift
switch the control mode of embedded DVR or speed dome
MENU
show the main menu
PREV
switch the previews of single, four, nine, twelve, sixteen screens
F1
Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation.
F2
Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation.
REC
Enter into DVR manual record menu.
MON
specially control the four auxiliary display output ports of DS-8016HSI (hold for 2
seconds )
EDIT
Enter into DVR edit mode.
F3
Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation.
PLAY
Enter into DVR playback menu.
MAIN/AUX
switch the main/aux output port (hold for 2 seconds)
A
switch input ways
F4
Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation.
PTZ
Enter into DVR PTZ control menu.
AUX
In DVR control mode, this button is reserved.
Shut Down
power off DVR
Addr choose addresses of PTZ or the device ID of embedded DVRs
Clear
clean currently input content
ENTER
confirm currently input content
Number.: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9 0-9
A – Z
A-Z (26 letters)
PRESET
Setup the speed dome preset position
FOCUS+
set the lens focus near
FOCUS-
set the lens focus far
DEL
Delete the speed dome preset position
ZOOM+
zoom in the lens
ZOOM-
zoom out the lens
SHOT
Call the speed dome preset position
IRIS+
open the lens iris
IRIS-
close the lens iris
Auto
Set the speed dome to auto rotate（depend on speed dome itself, please reference the
speed dome’s manual）
WIPER
on/off the wiper relay
To Next Page
Loading...
