DO NOT place the device in extremely hot, cold, dusty or damp
locations, and do not expose it to high electromagnetic radiation.
White Light Illuminator (If supported)
Possibly hazardous optical radiation emitted from this product.
DO NOT stare at operating light source. May be harmful to the
eyes.
Wear appropriate eye protection or DO NOT turn on the white light
when you assemble, install or maintain the camera.
Emergency
If smoke, odor, or noise arises from the device, immediately turn
off the power, unplug the power cable, and contact the service
center.
Time Synchronization
Set up device time manually for the first time access if the local
time is not synchronized with that of the network. Visit the device
via Web browse/client software and go to time settings interface.
Installation
This camera series shares a similar structure. We take one type
among this series for demonstration.
Make sure the device is firmly secured to any wall or ceiling
mountings.
Be sure that there is enough space to install the device and
accessories.
Make sure that the device in the package is in good condition and
all the assembly parts are included.
Make sure that the wall is strong enough to withstand at least 4
times the weight of the device and the mount.
Please make sure your power supply matches with your device.
Refer to the appropriate documentation for detailed information.
Make sure that the power has been disconnected before you wire,
install, or disassemble the device.
Make sure that no reective surface is too close to the device
lens. The IR light from the device may reect back into the lens
causing reection.
To Next Page
Loading...
Need help?
General
