Set up camera time manually for the first time access if the
local time is not synchronized with that of the network. Visit the
camera via Web browse/client software and go to time settings
interface.
Installaon
Make sure the device is firmly secured to any wall or ceiling
mountings.
Be sure that there is enough space to install the camera and
accessories.
Make sure that the device in the package is in good condition
and all the assembly parts are included.
Make sure that the wall is strong enough to withstand at least 4
times the weight of the camera and the mount.
The standard power supply is 12 VDC, please make sure your
power supply matches with your camera.
Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
Make sure that no reflective surface is too close to the camera
lens. The IR light from the camera may reflect back into the lens
causing reflection.
For device with this sticker, this device is intended
for installation in a restricted access location,
access can only be gained by service persons or by
users who have been instructed about the reasons for the
restrictions applied to the location and about any precautions
that shall be taken.
Symbols and Marks
Notice
To Next Page
Loading...
Need help?
General
