HIKVISION DS-2CE16H0T-ITE - Page 4

 Keep the camera away from liquid while in use for
non-water-proof device.
 While in delivery, the camera shall be packed in its
original packing, or packing of the same texture.
Mark Description
Table 0-1 Mark Description
Mark
Description
DC Voltage
1 Introduction
1.1 Product Features
The main features are as follows:
 High performance CMOS sensor
 Low illumination, 0.01 Lux@(F1.2, AGC ON), 0 Lux
with IR
 IR cut filter with auto switch
 OSD menu with configurable parameters
 Auto white balance
 internal synchronization
 SMART IR mode
 PoC (with -E)
 3-axis adjustment
Note:
For the models have PoC function, you can connect the
video cable of the camera to the PoC device to get the
power supply.
1.2 Overview
This manual applies to two types of bullet cameras.
The overviews of each type are shown in the figures
below.
1.2.1 Overview of Type I Camera
Main Body
Phototransistor
Lens
Bracket
Video Cable
Power Cord
12 VDC
Figure 1-1 Overview of Type I Camera
1.2.2 Overview of Type II Camera
Camera
Bracket
Video Cable
Power Cord
12 VDC
Lens
Phototransistor
Figure 1-2 Overview of Type II Camera