UM DS-2CE1xU8T-ITx 042618NA 3
1.1.6
Warnings
• In the use of the device, you must be in strict
compliance with the electrical safety regulations of
the nation and region.
• Input voltage should meet both the SELV (Safety
Extra Low Voltage) and the Limited Power Source
with 12 VDC according to the IEC60950-1 standard.
Refer to technical specifications for detailed
information.
• The camera is powered by the external DC power
supply (12 VDC, 1 A) that complies with the LPS,
and the output current of this external DC power
supply must be no more than 6 A.
• Do not connect multiple devices to one power
adapter to avoid over-heating or a fire hazard
caused by overload.
• Make sure that the plug is firmly connected to the
power socket.
• Make sure that the device is firmly fixed if wall
mounting or ceiling mounting is adopted.
• If smoke, odor, or noise rise from the device, turn
off the power at once and unplug the power cord,
and then contact the service center.
• Never attempt to disassemble the camera by
unprofessional personal.
1.1.7
Cautions
• Do not drop the camera or subject it to physical
shock.
• Do not touch sensor modules with fingers.
• Do not place the camera in extremely hot, cold
(the operating temperature shall be -40° to 60° C),
dusty or damp locations, and do not expose it to
high electromagnetic radiation.
• If cleaning is necessary, use a clean cloth with a bit
of ethanol, and wipe it gently.
• Do not aim the camera at the sun or extra bright
places.
• The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure
that the sensor surface will not be exposed to the
laser beam.
• Do not expose the device to high electromagnetic
radiation or extremely hot, cold, dusty, or damp
environments.
• To avoid heat accumulation, good ventilation is
required for the operating environment.
• Keep the camera away from liquid while in use for
non-waterproof devices.
• While in delivery, the camera shall be packed in its
original packing, or packing of the same material.
To Next Page
Loading...
