Figure 5-10 Motion Detection Settings-Expert
Steps:
(1) Set the Schedule Image Settings, there are OFF, Auto-Switch and Scheduled-Switch
selectable. If the schedule image switch mode is enabled, you can configure the
detection rule for the day and night separately.
OFF: Disable the day and night switch.
Auto-Switch: Switch the day and night mode according to the illumination
automatically.
Scheduled-Switch: Switch to the day mode and the night mode according to the
configured time. You need to set the start time and end time.
(2) Select Area from the dropdown list to configure.
(3) Set the values of sensitivity and percentage.
Sensitivity: The greater the value is, the easier the alarm will be triggered.
Percentage: When the size proportion of the moving object exceeds the predefined
value, the alarm will be triggered. The less the value is, the easier the alarm will be
triggered.
4. Set the Arming Schedule for Motion Detection.
(1) Click tab to enter the arming schedule setting interface.
To Next Page
Loading...
Need help?
General
