© Hikvision
Figure 5-38 Position Settings
2. Manually find the north position for the speed dome in Live View interface, and click Set at
North to set the north direction.
3. After the speed dome changes its direction, you can click Point to North and the speed dome
turns back to the north direction.
4. You can manually set GPS information including longitude and latitude.
5. Click to save the settings.
5.4.11 Rapid Focus
Purpose:
Rapid focus is a function to reduce time of focusing comparing with that of normal focusing. To
use the function, calibration should be done first.
Note: Rapid focus may not be supported by certain camera models.
Steps:
1. Enter the rapid focus interface
Configuration > PTZ > Rapid Focus
To Next Page
Loading...
