HIKVISION DS-2TD1217-6/PA Quick Start Guide

Thermal & Optical Network Turret Camera Quick Start Guide
11
2. Input the IP address into the address bar of the web browser, and click Enter to enter
the activation interface.
Note: The default IP address of the system is 192.168.1.64.
Figure 4-2 Activation Interface(Web)
3. Create a password and input the password into the password field.
STRONG PASSWORD RECOMMENDED– We highly recommend you create a
strong password of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, resetting the password monthly or weekly can better protect your
product.
4. Confirm the password.
5. Click OK to activate the system and enter the live view interface.
4.2.2 Activation via SADP Software
SADP software is used for detecting the online device, activating the device, and
resetting the password.
Get the SADP software from the supplied disk or the official website, and install the
SADP according to the prompts. Follow the steps to activate the system.
Steps:
1. Run the SADP software to search the online devices.
2. Check the device status from the device list, and select an inactive device.

HIKVISION DS-2TD1217-6/PA Specifications

General

Model	DS-2TD1217-6/PA
Category	Security Camera
Thermal Module: Image Sensor	Uncooled VOx Microbolometer
Resolution	160 × 120
Pixel Interval	17μm
Lens (Focal Length)	6.8mm
Aperture	F1.0
Visible Light Module: Image Sensor	1/2.7" Progressive Scan CMOS
Protection Level/IP Rating	IP67
Response Waveband	8μm ~ 14μm
Thermal Sensitivity/NETD	≤ 50mK
Digital Zoom	8x
Visible Light Module: Min. Illumination	0.01 Lux @ (F1.2, AGC ON)
Video Resolution	1920 x 1080
Frame Rate	25 fps
Image Settings	Brightness, Contrast, Saturation
Temperature Measurement Range	-20 °C to 150 °C
Temperature Measurement Accuracy	±2°C or ±2%
Video Output	1 Vp-p composite output (75 Ω/BNC)
Alarm Input	1
Alarm Output	1
RS-485	1-channel
Power Supply	DC12V ±25%
Working Temperature/Humidity	Humidity: 95% or less
Focus	Fixed