HIKVISION DS-2TD2636-15 - Set ONVIF; Set HTTP Listening

Thermal & Optical Bi-spectrum Network Camera User Manual
63
4. Select a protocol version and input related parameters.
5. Click Save.
Register status turns to Online when the function is correctly set.
11.10 Set ONVIF
If you need to access to the device through ONVIF protocol, you can configure the ONVIF user to
enhance the network security.
Steps
1. Go to Configuration → Network → Advanced Settings → Integration Protocol.
2. Check Enable ONVIF.
3. Click Add to configure the ONVIF user.
Delete
Delete the selected ONVIF user.
Modify
Modify the selected ONVIF user.
4. Click Save.
5. Optional: Repeat the steps above to add more ONVIF users.
11.11 Set HTTP Listening
The device can send alarms to destination IP or host name through HTTP protocol. The destination
IP or host name should support the HTTP data transmission.
Steps
1. Go to Configuration → Network → Advanced Settings → HTTP Listening.
2. Input Destination IP or Host Name, URL, and Port.
3. Click Test.
Note
Click Default to reset the destination IP or host name.
4. Click Save.