1. Enter the Limit configuration interface:
Configuration > PTZ > Limit
Figure 7-27 Configure the PTZ Limit
2. Click the checkbox of Enable Limit and choose the limit type as manual stops or scan stops.
Manual Stops:
When manual limit stops are set, you can operate the PTZ control panel manually only in the
limited surveillance area.
Scan Stops:
When scan limit stops are set, the random scan, frame scan, auto scan, tilt scan, panorama
scan is performed only in the limited surveillance area.
Manual Stops of Limit Type is prior to Scan Stops. When you set these two limit types at the
same time, Manual Stops is valid and Scan Stops is invalid.
3. Click the PTZ control buttons to find the left/right/up/down limit stops; you can also call the
defined presets and set them as the limits of the speed dome.
4. Click Set to save the limits or click Clear to clear the limits.
7.3.3 Configuring Park Actions
Purpose:
This feature allows the speed dome to start a predefined park action (scan, preset, pattern and
etc.) automatically after a period of inactivity (park time).
To Next Page
Loading...
Need help?
General
