HIKVISION DS-2TD8166-150ZH2F/V2 User Manual

User Manual of Thermal Bi-spectrum Network Speed dome
© Hikvision
iii
Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid
danger or property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
Warnings: Serious injury or death may be caused if any of these warnings are neglected.
Cautions: Injury or equipment damage may be caused if any of these cautions are neglected.
Warnings Follow these safeguards to prevent
serious injury or death.
Cautions Follow these precautions to prevent
potential injury or material damage.
Warnings
 The device should be used in compliance with local laws and electrical safety regulations. Refer to the
appropriate documentation for detailed information.
 The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and the Limited
Power Source (24 VAC/12 VDC). Refer to the appropriate documentation for detailed information.
 DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards caused by
overload.
 Make sure the plug is properly connected to the power socket.
 If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and
contact the service center.
 The installer and user are responsible for password and security configuration and its settings.
 Both internal and external grounds should be connected properly. (The cross section area of the grounding
wire must be no less than 4 mm2, and no less than that of the phase connector).
Cautions
 Do not drop the device or subject it to physical shock.
 Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
 Do not aim the lens at the sun or any other bright light.
 When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it may
burn out.
 Do not expose the device to high electromagnetic radiation or extremely hot, cold, dusty, or damp
environments.
 Place the device in a dry and well-ventilated environment.
 Keep non-waterproof devices away from liquids.
 Keep the device in original or similar packaging while transporting it.
 A few device components (e.g., electrolytic capacitor) require regular replacement. The average lifespan varies,
so periodic checking is recommended. Contact your dealer for details.
 Improper use or replacement of the battery may result in explosion hazard. Replace with the same or
equivalent type only. Dispose of used batteries in conformance with the instructions provided by the battery
manufacturer.
 Never attempt to disassemble the device.
0505121090118

HIKVISION DS-2TD8166-150ZH2F/V2 Specifications

General

Brand	HIKVISION
Model	DS-2TD8166-150ZH2F/V2
Category	Security Camera
Language	English