2 Installation
Before you start:
● Make sure the device in the package is in good condition and all
the assembly parts are included.
● The standard power supply is 24 VAC, please make sure your
power supply matches with your camera.
● Make sure all the related equipment is power-off during the
installation.
● Check the specification of the products for the installation
environment.
● Make sure that the wall is strong enough to withstand three
times the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to
the following precautions to prevent IR reflection:
Make sure that there is no reflective surface too close to the camera
lens. The IR light from the camera may reflect back into the lens
causing reflection.
Wall Mounting
Before You Start
Wall mounting bracket is not included in package. You need to
prepare a bracket in advance if you adopt this mounting type. The
shown bracket is for installation demonstration.
Type I and Type II camera follow similar installation procedures. The
following demonstration uses type I as an example.
To Next Page
Loading...
Need help?
General
