EasyManua.ls Logo

HIKVISION DS-2XE62 2F-IS Series

HIKVISION DS-2XE62 2F-IS Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Network Bullet Camera·Quick Start Guide
9
Make sure the power supply voltage is correct before using the
camera.
Do not drop the camera or subject it to physical shock.
To ensure explosion-proof performance, do not damage
explosion-proof surface.
Do not touch sensor modules with fingers. If cleaning is
necessary, use clean cloth with a bit of ethanol and wipe it
gently. If the camera will not be used for an extended period,
please replace the lens cap to protect the sensor from dirt.
Do not aim the camera at the sun or extra bright places.
Blooming or smearing may occur otherwise (which is not a
malfunction), and affect the endurance of sensor at the same
time.
The sensor may be burned out by a laser beam, so when any
laser equipment is in using, make sure that the surface of
sensor will not be exposed to the laser beam.
Do not place the camera in extremely hot, cold (the operating
temperature shall be -30 °C to +60 °C), dusty or damp locations,
and do not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for
operating environment.
To prevent accumulation of electrostatic charge, only damp
cloth can be used during the cleaning.
Keep the camera away from liquid while in use.
While in delivery, the camera shall be packed in its original
packing, or packing of the same texture.

Related product manuals