● All the electrical operation should be strictly compliance with
the electrical safety regulations, fire prevention regulations and
other related regulations of the nation and region.
● Make sure that the power has been disconnected before you
wire, install or disassemble the camera. Never wire, install or
disassemble the camera in explosive environment.
● The power source should meet limited power source or PS2
requirements according to IEC 60950-1 or IEC 62368-1
standard.
● Do not connect several devices to one power adapter as
adapter overload may cause over-heating or a fire hazard.
● To avoid fire danger caused by electrostatic charge, never touch
or wipe the camera in explosive environment. Perform the
wiping and replacing accessories only under non-explosive
environment with the provided glove.
● When the camera is installed on wall or ceiling, the device shall
be firmly fixed.
● If smoke, odors or noise rise from the camera, turn off the
power at once and unplug the power cable, and then contact
the service center.
● If the camera does not work properly, contact your dealer or
the nearest service center. Never attempt to disassemble the
speed dome yourself. (We shall not assume any responsibility
for problems caused by unauthorized repair or maintenance.)
Cautions
To Next Page
Loading...
