4.4 Recording
Before you start
Make sure the Encoder is connected with HDD or network disk, and the HDD or network disk has been initialized
for the first time to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording.
Steps:
1. Go to Configuration > Storage > Schedule Settings > Record Schedule to enter record schedule settings
page.
Figure 4. 5 Record Schedule Settings
2. Select the camera to configure the record schedule.
3. Check the checkbox of Enable to enable scheduled recording.
4. Select a Record Type. The record type can be Continuous, Motion Detection, Alarm, Motion | Alarm,
Motion & Alarm, and Event.
5. Drag the mouse on the time bar to set the record schedule.
6. Click Advanced to configure advanced record parameters.
7. If you want to copy the record schedule settings of the current camera to other cameras, click Copy to to copy
the settings.
8. Click Save to save the settings.
To Next Page
Loading...
