DS-7600 Series NVR User Manual
35
5. To acquire the time and date over an NTP (Network Time Protocol) Server, check the Enable NTP checkbox. You can set the interval
and enter your own NTP server.
6. Click the Apply button to save the settings and click to exit out of the menu. Clicking without clicking the Apply button
will exit the menu without saving.
Checking the Status of Your NVR
The current status of your NVR can be checked at any time by going to the System Information menu. The System Information menu can
be accessed by going to Menu > System Information.
Figure 39, System Information Menu
1. Select the Device Info tab to enter the Device Information menu to view the device name, model, serial No., firmware version, encode
version and verification code, as shown in Figure 39.
2. Select the Camera tab to enter the Camera Information menu to view the status of each camera, as shown in Figure 40.
To Next Page
Loading...
