DS-7600 Series NVR User Manual
34
Setting Date and Time
It is extremely important to set up the system date and time to accurately timestamp recordings and events.
1. Enter the System Configuration menu by going to Menu > System Configuration > General.
Figure 37, System Configuration Menu Time/Date Tab
2. Select the Time/Date tab (Figure 37).
3. The current system time and date as well as the time zone will be displayed. Using the directional buttons on the remote or the
mouse, selects the correct date, time and time zone.
4. To enable Daylight Savings Time:
1) Select a time zone that supports DST.
2) Check the Enable DST checkbox and click Customize button to pop up the DST Setting menu, as shown in Figure 38.
3) You can check the Auto DST Adjusting checkbox or manually check the date of the DST period.
4) Click the Apply button to confirm the settings. Click OK to return to the upper level menu.
Figure 38, DST Settings Menu
To Next Page
Loading...
