Need help?Do you have a question about the HIKVISION DS-7608NI-E2/8P and is the answer not in the manual?
General| Display modes | Live view |
|---|---|
| Maximum frame rate | 60 fps |
| Maximum resolution | 1920 x 1080 pixels |
| Alarm input channels | 4 |
| Video input channels | 8 channels |
| Alarm output channels | 1 |
| Resolution at capture speed | 1920x1080@60fps |
| Operating temperature (T-T) | -10 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| AC input voltage | 100 - 240 V |
| Power consumption (typical) | 10 W |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Ethernet LAN (RJ-45) ports | 9 |
| HDD interface | Serial ATA |
| Maximum storage capacity | 12 TB |
| Number of HDDs supported | 2 |
| Total installed storage capacity | 0 GB |
Weight and Dimensions| Depth | 290 mm |
|---|---|
| Width | 445 mm |
| Height | 45 mm |
| Weight | 1000 g |
Describes the physical front panel components and their functions.
Describes the physical rear panel interfaces and their connectivity.
Covers starting up, shutting down, and setting the admin password for the NVR.
Explains how to add and connect IP cameras to the NVR.
Details various operations available in live view mode using front panel or mouse.
Details how to configure Pan, Tilt, Zoom (PTZ) parameters for cameras.
Details setting up motion detection parameters and triggering recordings.
Explains searching and playing back video based on specific event types.
Covers methods for backing up recorded video data.
Guides on configuring motion detection alarms and response actions.
Explains how to configure actions like audible warnings and notifications.
Details configuring face detection alarms and sensitivity.
Explains setting up vehicle detection alarms, including lane and rule configurations.
Guides on setting basic network parameters like IP address and working mode.
Explains how to enable and configure HIK Cloud P2P for remote access.
Guides on initializing newly installed hard disk drives.
Details setting up alarms for HDD errors or abnormal status.
Offers solutions for common issues encountered with the NVR.
To Next Page
