DS-7600 Series NVR User Manual
33
C H A P T E R 3
Getting Started
Starting Up and Shutting Down Your NVR
Proper startup and shutdown procedures are crucial to expanding the life of your NVR.
Start Up Your NVR
• Ensure the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an Uninterruptible Power
Supply (UPS) be used in conjunction with the unit.
• Connect the NVR to a VGA/HDMI monitor. You will see the NVR menu system only when it’s connected to a VGA/HDMI
monitor.
• Press the POWER switch on the back rear panel. The unit begins to start up.
Shut Down Your NVR
1. Shutdown your NVR by going to Menu > Maintenance, click in the lower left corner to pop up the Shutdown menu (Figure 36).
Figure 36, Shutdown Menu
2. Select the Shutdown button.
3. Click the Yes button.
4. When the “Please power off,” prompt appears, press the POWER switch to power off.
Rebooting Your NVR
While in the Shutdown menu (Figure 36), you may also reboot the NVR by clicking Reboot.
Locking Your NVR
Locking your NVR will return you to Live Feed mode, which will require a correct user name and password to exit and perform operations.
You have two methods to lock your NVR:
• Enter the Shutdown menu by going to Menu > Maintenance > Shutdown, and click the Lock button.
• Click on the lower left corner of Menu interface to lock your NVR.
NOTES: You can also set auto lock time to lock the menu for a certain period inactivity. Enable auto locking by going to Menu >
System Configuration > General > More Setting and select time in the Auto Locktime drop-down list.
To Next Page
Loading...
