DS-7600 Series NVR User Manual
86
Figure 112, Privacy Mask Settings Menu
2. Select the camera to setup privacy mask in using the camera drop-down list on the upper left of the menu.
3. Click Enable Privacy Mask checkbox to enable privacy mask.
4. Up to four privacy masks can be used per camera and are shown using four different colors, yellow, green, blue, and grey. Using the
mouse, click and drag out rectangular boxes defining the desired zones.
5. You may clear a privacy zone at any time by clicking on the corresponding Clear Zone button or Clear All button to clear all zones.
6. Select the Apply button to save the privacy mask settings and select to return to the previous menu. Selecting without
clicking Apply will quit out of the menu without saving settings.
Configuring Tamper-proof
Tamper-proof detection can be used to recognize if an area of a camera is purposely covered and to respond accordingly.
To configure tamper-proof detection:
1. Enter the Tamper-proof menu, shown in Figure 113, by going to Menu > Cameras Setup > Tamper-proof.
.
To Next Page
Loading...
