Network Video Recorder User Manual
170
Figure 16-20 Restore Default Settings
2. Select the restore type from the following three options.
Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the recorder to inactive status.
Note
The recorder will reboot automatically after restoring to the default settings.
16.11 Schedule Reboot
The device will automatically restart according to the schedule.
Steps
1. Go to Maintenance → System Service → System Service → Schedule Reboot.
2. Check Enable.
3. Set the reboot schedule.
4. Click Apply.
16.12 Security Management
16.12.1 Configure ONVIF
ONVIF protocol allows the connection with third-party cameras. The added user accounts have the
To Next Page
Loading...
