Video Wall Controller • User Manual
14
Configure Display Effect
Click Display Effect Settings to configure basic screen parameters, Gamma table, receiving card
expansion parameters, and advanced image parameters and view the receiving card basic
parameters.
Configure Display Effect
Correct Screen or Seam
When you enable correction for the first time, load the original correction data to make the data in
the light board consistent with the data of the receiving card. Select File Correction if the light
board data is missing. Otherwise, select Manual Correction.
If there is color difference or seam, you can adjust the RGB values of the screen or seam.
Select manual correction:
1) Switch on Enable to start the correction configuration.
2) Select the corrected area.
− Click to select the area to be corrected.
Select Correction Area
To Next Page
Loading...
Need help?
General
