HIKVISION DS-K1T341CMF User Manual

It refers to the port through which the client adds the device.
Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go to
Conguraon → Network → Basic Sengs → Report Strategy .
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the
sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Advanced Sengs → Plaorm .
2.
Select ISUP from the
plaorm access mode drop-down list.
3.
Check Enable.
4.
Set the ISUP version, and view the alarm receiver type, server address, port, device ID, register
status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5.
Set the ISUP listening parameters, including ISUP alarm center IP address/domain name, ISUP
alarm center URL, and ISUP alarm center port.
6.
Click Save.
Plaorm
Access
Plaorm access provides you an opon to manage the devices via plaorm.
DS-K1T341C Series Face Recognion Terminal User Manual
103

HIKVISION DS-K1T341CMF Specifications

General

Type	Face recognition terminal
Product color	Black, Silver
Cards capacity	3000 cards
Event capacity	150000
Access code reader	-
Authentication type	Access chip/card, Face recognition
Face recognition distance	0 - 2 m
Face recognition duration	0.2 s
Access chip/card reader type	Contact
International Protection (IP) code	IP65
Operating system installed	Linux
Screen shape	Flat
Display diagonal	4.3 \
Maximum resolution	272 x 480 pixels
Touchscreen technology	Capacitive
Total megapixels	2 MP
Ethernet LAN data rates	10, 100 Mbit/s
Power consumption (typical)	10 W
Operating temperature (T-T)	-30 - 60 °C