HIKVISION DS-K1T341CMF User Manual

Click Save to save the sengs aer the conguraon.
No.
Set the RS-485 No.
Peripheral Type
Select a peripheral from the drop-down list according the actual situaon. You can select from
Card Reader, Extension Module, Access Controller, or Disable.
Note
Aer the peripheral is changed and saved, the device will reboot automacally.
RS-485 Address
Set the RS-485 Address according to your actual needs.
Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
Baud Rate
The baud rate when the devices are communicang via the RS-485 protocol.
Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1.
Click Conguraon → Access Control → Wiegand Sengs .
DS-K1T341C Series Face Recognion Terminal User Manual
117

HIKVISION DS-K1T341CMF Specifications

General

Type	Face recognition terminal
Product color	Black, Silver
Cards capacity	3000 cards
Event capacity	150000
Access code reader	-
Authentication type	Access chip/card, Face recognition
Face recognition distance	0 - 2 m
Face recognition duration	0.2 s
Access chip/card reader type	Contact
International Protection (IP) code	IP65
Operating system installed	Linux
Screen shape	Flat
Display diagonal	4.3 \
Maximum resolution	272 x 480 pixels
Touchscreen technology	Capacitive
Total megapixels	2 MP
Ethernet LAN data rates	10, 100 Mbit/s
Power consumption (typical)	10 W
Operating temperature (T-T)	-30 - 60 °C