HIKVISION DS-K1T341CMF User Manual

Figure 9-5 Display the Selected Person(s) and Access Point(s)
8.
Aer adding the access groups, you need to apply them to the access control device to take
eect.
1) Select the access group(s) to apply to the access control device.
2) Click Apply All to Devices start applying all the selected access group(s) to the access control
device or door
staon.
3) Click Apply All to Devices or Apply Changes to Devices.
Apply All to Devices
This
operaon will clear all the existed access groups of the selected devices and then
apply the new access group to the device.
Apply Changes to Devices
This operaon will not clear the existed access groups of the selected devices and only
apply the changed part of the selected access group(s) to the device(s).
4) View the applying status in the Status column or click Applying Status to view all the applied
access group(s).
Note
You can check Display Failure Only to lter the applying results.
The selected persons in the applied access groups will have the authorizaon to enter/exit the
selected doors/door
staons with their linked card(s) or ngerprints.
9.
Oponal: Click to edit the access group if necessary.
DS-K1T341C Series Face Recognion Terminal User Manual
156

HIKVISION DS-K1T341CMF Specifications

General

Type	Face recognition terminal
Product color	Black, Silver
Cards capacity	3000 cards
Event capacity	150000
Access code reader	-
Authentication type	Access chip/card, Face recognition
Face recognition distance	0 - 2 m
Face recognition duration	0.2 s
Access chip/card reader type	Contact
International Protection (IP) code	IP65
Operating system installed	Linux
Screen shape	Flat
Display diagonal	4.3 \
Maximum resolution	272 x 480 pixels
Touchscreen technology	Capacitive
Total megapixels	2 MP
Ethernet LAN data rates	10, 100 Mbit/s
Power consumption (typical)	10 W
Operating temperature (T-T)	-30 - 60 °C