HIKVISION DS-K1T673DWX User Manual

You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Advanced Sengs → Plaorm .
2.
Select ISUP from the
plaorm access mode drop-down list.
3.
Check Enable.
4.
Set the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5.
Click Save.
Congure
HTTP Listening
The device can send alarm informaon to the desnaon IP or host via HTTP protocol/HTTPS
protocol.
Before You Start
The
desnaon IP or host name should support the HTTP protocol/HTTPS protocol to receive the
alarm informaon.
Note
The funcon should be supported by the device.
Steps
1.
Click
Conguraon → Network → Advanced → HTTP Listening .
2.
Edit the desnaon IP or host name, URL and port.
DS-K1T673 Series Face Recognion Terminal User Manual
90

HIKVISION DS-K1T673DWX Specifications

General

Brand	HIKVISION
Model	DS-K1T673DWX
Category	Touch terminals
Language	English