HIKVISION DS-K5032 Series - System Settings

7.4.3 System Sengs
Set Network Parameters
You can set wired network or Wi-Fi for the device.
Steps
1.
Tap in the top right corner of the home page. Tap Communicaon Sengs → Wired Network
or Communicaon Sengs → Wi-Fi according to your actual needs.
2.
Set network.
Wired Network
Note
Make sure the device has connected to a network.
Figure 7-22 Wired Network
If enable DHCP, the system will assign the IP address and other parameters automacally.
If disable DHCP, you should set the IP address, the subnet mask, and the default gateway,
DNS1 and DNS2.
Tap
to save the sengs.
Wi-Fi
DS-K5032 Series Visitor Terminal User Manual
40