55
Set Arming/Disarming Schedule
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → Area to enter the page.
3. Tap an area in the list, enable the area and select linked areas.
4. Enable the auto arm/disarm function and set the auto arm time/auto disarm time. You can also
set the late to disarm time, entry delay time, exit delay time, sounder delay time, weekend
exception and excepted holiday.
Auto Arm
Enable the area to automatically arm itself in a specific time point.
Auto Arm Time
Set the schedule for the area to automatically arm itself.
Auto Disarm
Enable the area to automatically disarm itself in a specific time point.
Auto Disarm Time
Set the schedule for the area to automatically disarm itself.
Late to Disarm
Enable the device to push a notification to the phone or tablet to remind the user to disarm the
area when the area is still armed after a specific time point.
Note
You should enable the Panel Management Notification function on the Web Client of
Communication Parameters → Event Communication before enabling the Late to Disarm
function.
Late to Disarm Time
Set the time point mentioned in Late to Disarm.
Auto Arm Sound Prompt
After disabled, the buzzer will not beep before auto arming.
Weekend Exception
If enabled, Auto Arm, Auto Disarm, and Late to Disarm are disabled on the weekend.
Holiday Excepted
Enable the function and the zone will not be armed/disarmed in the holiday. You should set the
holiday schedule after enabling.
To Next Page
Loading...
Need help?
General
