ECI-T24Fx Quick Start Guide
QSG ECI-T24Fx 041018NA 12
Select inactive device.
Input and confirm
password.
SADP Interface
Figure 3-4
Note:
SADP supports batch camera activations. Refer to the SADP user manual for further details.
3. Create, input, and confirm the password.
STRONG PASSWORD RECOMMENDED – We highly recommend creating a strong
password of your own choosing (using a minimum of eight characters, including
upper case letters, lower case letters, numbers, and special characters) in order to
increase the security of your product. We recommend regularly resetting your
password on a weekly or monthly basis, especially in high security systems.
Note:
You can enable the Hik-Connect service for the device during activation. Refer to Chapter
5.1 for detailed information.
4. Click Activate to start activation.
You can check whether the activation is complete in the popup window. If activation failed,
make sure that the password meets the requirements, and try again.
3.5 Modify the IP Address
Purpose:
To view and configure the camera via LAN (Local Area Network), you need to connect the
network camera in the same subnet as your PC.
Use the SADP software or client software to search and change the IP address of the device.
IP Address modification via SADP software will be used as an example.
In order to modify the IP address via client software, refer to the user manual of the client
software.
Steps:
1. Run SADP.
2. Select an active device.
3. Change the device IP address to the same subnet as your computer by either modifying
the IP address manually, or by checking the Enable DHCP checkbox.
To Next Page
Loading...
Need help?
General
