Need help?Do you have a question about the HIKVISION DS-2CD7253F-EIZ and is the answer not in the manual?
General| Image Sensor | 1/3" Progressive Scan CMOS |
|---|---|
| Max Resolution | 1920 x 1080 |
| Min. Illumination | 0.01 Lux @(F1.2, AGC ON), 0 Lux with IR |
| Wide Dynamic Range | Digital WDR |
| Video Compression | H.264 / MJPEG |
| Ingress Protection | IP67 |
| IR Range | Up to 30 m |
| Lens | 2.8 mm |
| Day & Night | IR Cut Filter |
| Image Settings | Saturation, Brightness, Contrast adjustable by client software or web browser |
| Network Storage | NAS |
| Protocols | TCP/IP, HTTP, DHCP, DNS, DDNS, RTP, RTSP, PPPoE, SMTP, NTP, SNMP, HTTPS, FTP, 802.1x, Qos |
| General Function | Motion detection, tampering alarm |
| Communication Interface | 1 RJ45 10M/100M Ethernet port |
| Operating Conditions | -30 °C to +60 °C |
| Power Supply | PoE (802.3af) |
| Effective Pixels | 2.07 MP |
| Power Consumption | Max. 5.5W |
Illustrates the wiring diagram and notes the reset function for Cube Camera I.
Explains the purpose and basic cable connection for setting up a camera over LAN.
Details how to use SADP software to find and identify network cameras on the LAN.
Guides users on how to modify network parameters like IP address using SADP software.
Lists the necessary system and browser requirements for accessing the camera via web browser.
Details how to adjust browser security settings, particularly for ActiveX controls.
Guides users through the login process and installing the necessary plug-in for camera management.
Details the final steps for plug-in installation and re-logging into the camera interface.
To Next Page
