HIKVISION iDS-TCE500-B

Figure 6-2 Connect to ISUP Plaorm
2.
Check Enable ISUP.
3.
Select Protocol Version.
4.
Select Address Type.
5.
Enter Sever IP Address, Server Port, and Device ID.
Note
You need to enter Key if you select Protocol Version as v5.0.
6.
Oponal: For protocol v5.0, you can enable Upload Binary Image if you need to upload images
which are full of black or white pixel points.
Note
Enable Output Binary Image in BMP Format if you want to output images in this format.
7.
Click Save.
8.
Oponal: View Register Status.
Note
When the registraon status shows online, you can add or manage the device via the plaorm
soware. Refer to its corresponding manual for details.
6.2.2 Connect to Hik-Connect
The device can be remotely accessed via Hik-Connect.
Network Trac Camera Operaon Manual
34