UM DS-2CCx2D9T-xxxx 022520NA (UD02874B-A) 15
Cautions
Make sure the power supply voltage is correct before using the
camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary,
use a clean cloth with a bit of ethanol, and wipe it gently. If the
camera will not be used for an extended period, replace the lens cap
to protect the sensor from dirt.
Do not aim the camera at the sun or extra bright places. Blooming or
smearing may occur otherwise (which is not a malfunction), and
affect the endurance of sensor at the same time.
The sensor may be burned out by a laser beam, so if any laser
equipment is in use, make sure that the sensor surface will not be
exposed to the laser beam.
Do not place the camera in extremely hot, cold, dusty, or damp
locations, and do not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for the
operating environment.
Keep liquid away from the camera while in use.
Pack the camera in its original packing or equivalent while in transit.
To Next Page
Loading...
Need help?
General
