Hills Wireless DIY security alarm starter kit - Table of Contents

2
Features
1 Introduction 3
1.1 Box Content 3
1.2 Features 3
1.3 Recommendations 4
1.4 Warnings 4
2 Easy Install 5
2.1 Insert SIM card into the alarm panel and install in desired location 5
2.2 Register accessories with the alarm panel 6
2.3 Download App and set your personal alarm settings 7
3 Alarm settings 8
3.1 Enter Setup Mode 8
3.2 Exit Setup Mode 8
3.3 Store phone numbers 8
3.4 Delete phone numbers 9
3.5 Change password 9
3.6 Set Siren volume 9
3.7 Set Siren ring time 9
3.8 Set Entry and Exit delay 9
3.9 Clear connected sensors 9
4 Control your alarm 10
4.1 Arm your system 10
4.2 Disarm your system 10
4.3 Home mode 10
4.4 Mute mode 10
4.5 Emergency mode 10
4.6 Make a phone call 11
4.7 Speed Dial 11
4.8 Remotely control your alarm 11
5 Responding to an alarm 12
6 Specifications 13
6.1 Alarm panel 13
6.2 Wireless remote 16
6.3 Wireless motion sensor 17
6.4 Wireless door/window sensor 20
6.5 RFID Tag 22
6.6 SMS operation 23
6.7 Assign sensors to zones 28
7 FAQ 30
Thank you for purchasing the Hills
Wireless Security Alarm DIY Starter Kit.
Please read this manual carefully to get
the best use out of this product. Keep
this manual for future reference.
1 Introduction
1.1 Box Content
1 x Alarm Panel (with internal siren)
2 x Remote Controls
1 x Wireless Motion Sensor
1 x Wireless Window/Door Sensor
2 x RFID Tags
1 x AC Adaptor
2 x 800 mAh Batteries
(8hr in standby mode)
2 x Security Warning Stickers
NOTE: You will need to supply your
own SIM card for use with this system
TE0166_Wireless_Security_Alarm_Kit_Prod_Manual_PM1004a_R1.indd 2 27/02/2015 4:24 pm