Why is my Hilti Nail Gun overheating?
If the spring element is not re-tensioned and the status indicator flashes green while 4 battery charge status LEDs flash on your Hilti Nail Gun, it means the fastening tool has overheated. To resolve this, allow the fastening tool to cool down.
Why is the spring element not tensioned and the status indicator flashes red on my Hilti BX 3 Nail Gun?
If the spring element is not tensioned and the status indicator on your Hilti Nail Gun flashes red, the fastener guide may not be fitted correctly. To resolve this, insert the fastener guide properly.
What to do if my Hilti BX 3 Nail Gun overheats?
If the spring element is not re-tensioned and the status indicator flashes green while all 4 battery charge status LEDs flash on your Hilti Nail Gun, it means that the fastening tool has overheated. Allow the fastening tool to cool down.
What to do if the spring element is not tensioned and the status indicator flashes red on my Hilti Power Tool?
If the spring element is not tensioned and the status indicator flashes red on your Hilti Power Tool, the fastener guide might not be fitted correctly. Try inserting the fastener guide.
Why is the status indicator red and the spring element not tensioned on my Hilti Power Tool?
If the spring element isn't tensioned and the status indicator lights up red on your Hilti Power Tool, it indicates a system fault. Try removing and fitting the battery.
Why is my Hilti Power Tool not re-tensioning and the status indicator flashes green while 4 battery charge status LEDs flash?
The fastening tool may have overheated. Allow the fastening tool to cool down.
What to do if the spring element is not ten- sioned and the status indicator flashes green, plus 1 battery charge status LED flashes on my Hilti Power Tool?
This can happen if the battery is empty, in which case you should change the battery. It can also happen if the battery temperature is too low, in which case you should allow the battery to warm up slowly to room temperature.
How to fix a Hilti Power Tool when the fastener guide cannot be pressed in and the status indicator lights green?
This issue can arise due to several reasons: * The magazine might be empty; in this case, load the magazine. * The nail pusher could be jammed; if so, remove the nail strips from the magazine and clean the magazine. * A nail might be jammed in the fastener guide.
Why is my Hilti Power Tool spring element not ten- sioned; no status indication?
This problem may occur due to two possible reasons: * The battery is empty. Replace the battery. * The battery is not fitted correctly. Fit the battery.
What to do if the spring element is not ten- sioned and the status indica- tor flashes red on my Hilti Power Tool?
The fastener guide may not be fitted correctly. Insert the fastener guide.
General| Power Source | Battery |
|---|---|
| Fastener Type | Nails |
| Magazine Capacity | 30 nails |
| Battery Voltage | 22 V |
| Width | 134 mm |
To Next Page
