English 9
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Setting the torque
▶ Push the torque selector button repeatedly until the desired torque setting is displayed in the torque
display.
6.2 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired direction of rotation.
◁ The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
An interlock prevents switching while the motor is running.
6.3 Switching on
▶ Press the control switch.
◁ Speed of rotation is regulated by the distance the control switch is pressed in.
6.4 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be damaged if torque is too high. This
presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced by the tool.
1. Move the forward/reverse switch into the middle position.
2. Use the torque selector button to set the desired torque. → page 9
3. Set the forward/reverse switch to the desired direction of rotation.
Printed: 18.06.2018 | Doc-Nr: PUB / 5293904 / 000 / 02Printed: 18.06.2018 | Doc-Nr: PUB / 5293904 / 000 / 03
To Next Page
Loading...
