(Brake Maintenance is quoted from https://www.tektro.com/ , for further information
and instructions please go to https://www.tektro.coload.php)
Adjust Lever Reach (See 4f - 4g)
4f. Tool free reach adjustment type-by the reach adjustment knob on the lever.
4g. By tightening the 2 mm reach-adjuster bolt on the lever.
If there is lasered "5.0mm Pad" and (or) “2.3mm rotor only" or "E.2.3" on the caliper of
your hydraulic disc brakes, please make sure to replace your brake pads and rotors
according to the original setup of each model. You can find more information about
2.3mm rotors and 5.0mm pads on TEKTRO website. (See 4i).
Rotor replacement:
2.3mm thickness rotor should be replaced if worn to 1.9mm thickness.
1.8mm thickness rotor should be replaced if worn to 1.5mm thickness.
* Himiway has the right, without notice to the consumer, to substitute components of at
least equal quality for advertised Himiway e-bike components if those advertised
components are unavailable.
WARNING: TEKTRO had implemented 2 key improvements this year for better
performance, 2.3mm thickness rotors and 5.0mm brake pads.
4e4d
2mm Allen wrench
4g
4f
Tool free reach adjustment
4i4h
Pad number
4j
Rotor
number
15
Warranty
Himiway Bikes periodically updates our official Warranty Policy. Therefore, please review
the latest policy on our website:
https://himiwaybike.com/pages/warranty
After-sales Mail: customers@himiwaybike.com
Suggestion Box: mike@himiwaybike.com
To Next Page
Loading...
