◆ Security Passcode
To prevent theft or unauthorized use of your e-bike, you may set a security passcode to prevent use of the motor/electronics (though still permitting manual
pedalling).
Press “ + ” several times to arrive at display #8 (number shown at top right). Display will then show the passcode Input screen (“PS”).
Press “ ” to arrive at the Second passcode screen (“P2”), and enter the 4-digit second passcode of 1212.
Press “ + ” and “ - ” to adjust numbers up/down.
Press “ ” to confirm.
Press “ + ” and “ - ” to adjust numbers up/down.
Press “ ” to confirm.
•
•
•
•
Hold “ + ” and “ - ” together for two seconds, first bringing you to the trip meter reset screen described above.
Then, hold “ - ” and “ ” keys together for two seconds, bringing you to the passcode screen (“ P ”). Here you can enter the 4-digit passcode, which again
is 0510.
1.
2.
3.
4.
NOTICE: It is not recommended to change the default power-on passcodes of the
display (1212) or change the passcodes of the system (0510). We suggest you take
down the passcodes on the inside front cover of this manual.
25
To Next Page
Loading...
