When using a gear system, try not to skip gears, which can easily damage the gear. It is not possible to change two gears at a time above, should be
a level of adjustment, can better protect the gear system.
Battery instructions
Battery removal and installation
First place one end of the battery in the
slot
Aim the other end of the battery at the
charging port, press it gently and fasten
the latch
Key return, battery installed
Turn the key, the battery pops up,
and the battery is taken out
Battery charging
Open the soft cover on the side of the battery
The power supply pin of the charger is
inserted into the charging port of the battery,
and the power supply pin at the other end is
connected to the power supply
When charging, the charger status light is red
When the battery is fully charged, the charger
status light is green and the charging is finished
Unplug the charger for safekeeping and
close the soft cover
If the battery is charged in the bike, please turn off
the instrument power
The power supply plug
Power supply pin
lamp
Charging port
Soft cover
Key
Buckle
Plug
Frame charging port
Charging port
To Next Page
Loading...
