HIMO Z16 - Trouble Removal

Trouble Removal
Insufficient endurance
No power after switching on
No display on the dashboard
QUESTIONS Cause Solution
No power output of the
motor after switching on
The battery fails to be
charged.
Check if the dash is plugged properly.
Low voltage of the battery. Charge the battery.
The bicycle isn't powered
The bicycle is braking.
The bicycle is parked.
The speed is lower than 5km/h.
Failure of the starting switch.
Check if the brake crank is braking.
Release the bicycle from "Park".
Pedal the bicycle to accomplish a speed of 5km/h.
Contact the after-sales service department.
The battery isn't fully charged.
Insufficient tire pressure.
Frequent braking and starting.
The battery is aged or faded normally in
capacity.
Low ambient temperature, causing the
battery faded in capacity.
The charger isn't plugged in properly.
Low battery temperature.
High battery temperature.
Check the charger for damage.
Check the tire pressure before each use.
Develop a good driving habit.
Replace the battery.
Normal.
Check if the plug is loose.
Wait for the battery to be with a charging temperature.
Wait for the battery to be with a charging temperature.
The bicycle isn't powered.
The dash isn't plugged in properly.
Low voltage of the battery. Charge the battery.
Check the plug of the dash.