14
Always open/close the battery door to connect
When connecting the hearing instruments to the fitting software
make sure to always bring the hearing instruments into “Fitting
mode” by rebooting them. This is done by opening and closing
the battery door of the hearing instrument one time.
By doing so it is possible for the fitting software to discover and
communicate with the hearing instruments.
Note: If a hearing instrument is accidently put into flight mode
where all wireless operation is disabled, just open and close
the battery door again. After 10 seconds wireless operation is
resumed. Keep the battery door closed for an additional 15 sec-
onds after wireless operation has been resumed before opening
and closing the battery door again. Opening and closing the bat-
tery door within 15 seconds will put the hearing instrument into
flight mode again.
For more information about Flight Mode please refer to the rel-
evant wireless hearing instrument user guide.
After having completed the fitting make sure to open and close
the battery door to reboot the instruments saving all settings.
To Next Page
Loading...