GH F33 BDA
2. run up of engine in a speed range where centrifugal clutch is positioned without fixed
gearing. Because in this case the run up range is very slow, the time of run up should be
longer.
Attention !
If the warm up or other engine operation is carried out in the range where the clutch engages,
the result may be increased wear on the surface, glazing of the coating, or overheating of the
clutch.
2.4 Operation conditions
During operation of the engine, cylinder head- and exhaust gas temperatures have to be
controlled. If permissible maximum temperature of cylinder head and/ or exhaust are not
exceed, engine can run without limit (also full load in maximum performance). It is also
recommended to control fuel pressure during operation. Lack in fuel pressure can cause loss
in performance and set out engine.
2.5 cut off the engine
Before engine is cut off, it should be run one minute at idle power in unencumbered state.
This proceeding always should be noticed because an engine load tends to overheat when it is
cut off after highest load.
Stand: 02.02.05 DOC_F33_B_E_0.01
To Next Page
Loading...
