1
CAUTION
Be sure to disconnect the AC power cord before installing a stand or wall mount
brackets.
The display on your TV is fragile. Make sure the TV screen is not scratched or damaged
by hard objects or from pressure.
After the installation is completed, make sure the TV is steady on a table or firmly attached
to a wall mount, before removing all protective film, if any.
Installing the Stand or Wall Mount Bracket
Installing the stand
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the TV or
scratching to the screen.
2. Take out the 2 stands from the accessory bag and then insert the stands into the bottom
slots of the TV.
3. Secure the stands to the TV with the 4 screws in accessory tightly.
Follow the illustrations and textual instructions below to complete the installation steps:
43"
Screws: M4×16
50"/55"/58"/65"
Base Stand
Base Stand
Note: If your table is long enough to place the TV on top of, then insert the base stands into the
screw holes ‘A’ that are shown in the illustration. If your table is NOT long enough, then insert
the base stand into the screw holes ‘B’ that are shown in the illustration. Note that these two
installation methods cannot be mixed.
75"
Screws:
M5×12
Base Stand
A
A
Base Stand
43"/50"/55"/58"/65"/75"
Base Stand
Screws: M5×12
Base Stand
To Next Page
Loading...
