6
To attach the left and right leg that forms the stand:
1. Carefully place your TV face down on a soft, flat surface to prevent the TV from
being damaged or the screen from getting scratched.
2. Remove the 2 legs from the foam and then insert the legs into the bottom slots of
the TV.
3. Use the screws that came inside the carton with your TV to secure each leg tightly.
STEP 1. Attach the TV stand or wall mount bracket (not
included)
Attach the TV Stand
CAUTION:
Be sure to disconnect the A/C power cord before installing a stand or Wall-Mount
brackets.
The LED display is very fragile and must be protected at all times when installing
the legs that form the stand. Be sure to protect the TV screen from getting
scratched or damaged by any hard objects. In addition, DO NOT exert pressure on
the front of the TV at any time because it could crack.
After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
43"/50"/55"
Screws:
M4×16 (43")
M4×12 (50"/55")
Leg
Leg
Screws:
M4×16 (43")
M4×12 (50"/55")
To Next Page
Loading...
Need help?
General
