8
Complete Installation
1. Place the window-lock bracket on top of the lower window and
against the upper window sash.
2. Use 1/8” drill bit to drill a starter hole through the hole in the
bracket.
3. Attach the window-lock bracket to the window sash with wood
screw(provide 4) to secure the window in place.
A. Upper window sash
B. Window-lock bracket
4. Insert the foam seal behind the top of the lower window sash
and against the glass of the upper window.
A. Top of lower window sash
B. Foam seal
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
WARNING
fire, or electrical shock.
5. Plug into a grounded 3 prong outlet.
6. Press RESET on the power supply cord. see “Electrical
Requirements.”
PORTABLE AIR CONDITIONER USE
Operating your air portable conditioner properly helps you to
obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
The air conditioner display shows the current room
temperature.
When changing modes while the air conditioner is
operation, the compressor will stop for 3 to 5 minutes before
restarting.
■
■
If a button is pressed during this time, the compressor will
not restart fo another 3 to 5 minutes.
In Cooling or Dry mode, the compressor and condenser fan
will stop when the room temperature reaches the set
temperature.
■
A
B
To Next Page
Loading...
Need help?
General
