Problem Possible cause & Solution
A layer of frost
occurs i n the
compartment
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation. Ensure
that door is fully closed. To remove the frost,please refer to
cleaning and care chapter.
Temperature inside
is too warm
You may have left the doors open too long or too frequently; or the
doors are kept open by some obstacle; or the appliance is located
with insufficient clearance at the sides,back and top.
Temperature inside
is too cold
Increase the temperature by following the"Display controls"
chapter.
Doors can't be
cloased easily
Check whether the top of the refrigerator is tilted back by 10-15mm
to allow the doors to self close, or if something inside is preventing
the doors from closing.
Water drips on the
floor
he water pan (located at the rear bottom of the cabinet) may not be
properly leveled, or the draining spout underneath the top of the
compressor depot may not be properly positioned to direct water
into this pan, or the water spout is blocked, or the water is not fully
inserted into the connector. You may need to pull the refrigerator
away from the wall to check the pan and spout and connector.
The light is not
working
l The LED light may be damaged. Refer to replace LED lights
in cleaning and care chapter.
l The control system has disabled the lights due to the door
being kept open too long, close and reopens the door to
reactivate the lights.
Ice is not dispensing
l Did you wait for 4 hours after installation of the water supply
line before making ice? if it is not sufficiently cool, it may take
longer to make ice, such as when first installed.
l Is the water line connected and the water valve open?
l Did you manually stop the ice making function? Make sure
you have set the Cubed or Crushed mode on.
l Is there any ice blocked within the ice maker bucket or ice
chute?
l Is the freezer temperature too warm?Try setting the freezer
temperature lower.
To Next Page