Steps for installation
Remove packaging materials
Failure to remove packaging materials could result in damage to the appliance. Remove all packing
parts from the oven, racks, heating elements and drawer. Also remove protective film and labels on
the door, cooktop and control panel.
Prepare the opening
(for indoor use only)
See ilustrations for all rough-in and spacing
dimensions. The appliance may be placed with
0'' clearance (flush) at the back walls and side
walls of the cabinets.
A. Recommended acceptable electrical outlet
area. Orient the electrical receptacle so the
length is parallel to the floor.
EN 5
To Next Page
Loading...
