Hisense HSGP15FB - Settings

Settings
1.
Press .
2.
To open the dishwasher settings menu, press and hold and until SEt is shown on the display.
3.
Press to move through the settings menu.
4.
Press to move through the alternatives.
5.
Use to confirm selected setting.
6.
To exit the menu, skip through it or press .
Confirm / Next settingSelect alternative
Open the dishwasher settings menu
AlternativesSettings
You can activate the Automatic child lock setting to prevent
children from starting the dishwasher.
1:00 (Off)
1:01 (On)
Automatic child lock
CL
To temporarily deactivate or activate the Automatic child
lock setting, press and hold for three seconds.
CL (Child Lock) will be shown on the display when pressing
the control panel. (To unlock, press and hold for three
seconds.)
A beep confirms that the display has been pressed.2:00 - 2:03Sounds
The buzzer indicates when a dishwashing program has
ended.
(00 Off)
Error messages are always indicated by a loud buzzer.
Setting for rinse aid dosage. The rinse aid dispenser can
be adjusted between 00 (Off) and 05 (High dosage).
3:00 - 3:05
(00 Off)
Rinse aid
Increase the rinse aid dosage:
• If the dishes have water marks.
Decrease the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Build-up of foam. If you have very soft water, the rinse
aid can be diluted 50:50 with water.
Pre-selected at factory: 04
Activate this setting when using an all-in-one detergent that
contains rinse aid.
5:00 (Off)
5:01 (On)
TAB
21