27
Temperature inside is
too warm
You may have left the doors open too long or too
frequently; or the doors are kept open by some obstacle;
or the appliance is located with insufficient clearance at
the sides, back and top .
Temperature inside
is too cold
Doors can’t be
closed easily
Increase the temperature by following the“Display controls”
chapter.
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close, or if something
inside is preventing the doors from closing.
Water drips
on the floor
●
●
The LED light may be damaged Refer to replace LED
lights in cleaning and care chapter.
The controI system has disabled the lights due to the
door being kept open too long,close and reopens the door
to reactivate the Iights.
.
The light is not working
Alayer of frost occurs
in the compartment
Check that the air outlets are not blocked by food and
ensure food is placed within the appliance to allow
sufficient ventilation.Ensure that door is fully closed.To
remove the frost, please refer to the“Cleaning and care”
chapter.
The water pan (located at the rear bottom of the cabinet)
may not be properly leveled, or the draining spout under
neath the top of the compressor depot may not be properly
positioned to direct water into this pan, or the water spout is
blocked. Youmay need to pull the refrigerator away from the
wall to check the pan and spout.
Check if the refrigerator is power-offfor a long time, this may
cause the ice in the bucket to melt into water,and flow to the
floor .
57 / 61
To Next Page
Loading...
Need help?
General