Hisense RD-60WC1STA/USE-002 - Page 35

32
6.3.2.1 Compressor protector test
Use a multi-meter to test the resistance between the two end as the pic show :
If there show 000 or almost 0 then it is OK.
If there is no response then it is broken.
6.3.2.1 Comp
●
ressor PTC starter test
Use a multi-meter to test the resistance between the two end as the pic show :
If there show the number is between About 15 ± 5Ω then it is OK.
If there show 000 or no response then it is broken.