34
6.4 Fan motor
6.4.1 Basic parameters
Freezer Fan motor(F. Fan motor)
Rated voltage:DC12V
Rated input power:
＜
2.5W
6.4.1.1Checking method[Fan motor(F. Fan motor)]
（
（（
（Models with ice maker）
））
）
1.Check the connecting wiring of fan motor is well or not, repair if it is broken. The freezer fan
motor corresponding pin No.13~15 on15 pins connector of main control board.
2. Pin No.14 connect 12V power and pin No.13 connect GND. If the freezer fan motor works
normally, change the main control board; If not, change the fan motor.
6.4.1.2Checking method[Fan motor(F.
●
Fan motor)]（
（（
（Models without ice
maker）
））
）
1.Check the connectin
●
g wiring of fan motor is well or not, repair if it is broken. The freezer fan
motor corresponding pin No.1~3 on 5 pins connector of main control board.
2. Pin No.1 connect 12V power and pin No.2 connect GND. If the freezer fan motor works
normally, change the main control board; If not, change the fan motor .
6.4.2 Removing the fan motor
1. Unplug the appliance.
2. Open and remove the freezer door totally
，
then remove the drawers as picture 1
3. Remove the three screws by screwdriver as picture 2.
4. Catch the below of the wind channel component and pull down it as picture 3
5. Unplug the terminal as picture 4 and remove the wind channel component as picture 5.
6. Loosen the cable and cut the cable tie as picture 6 and 7.
7. Open buckles then separate two part of the wind channel component as picture 8 and 9
To Next Page
Loading...
